View Short term and Long term Savings by installing our PFCD Device

Calculate your Savings Using the Our Electric Bills Savings Calculator

FREE Energy Saving Tips

SOLAR HOT WATER BY FAFCO Read More

RESIDENTIAL, BUSINESS, COMMERCIAL, INDUSTRIAL CLIENTS CAN ALL SAVE

See what our Residential Customers have to say Read More

Commercial Clients Benefit 8% to 25% Savings Read More

USING POWER FACTOR CORRECTION TO REDUCE YOUR ENERGY CONSUMPTION

8% to 25% GUARANTEED

60 DAY MONEY BACK GUARANTEE

RECAPTURE ELECTRICITY, REDUCE ELECTRICITY, REDUCE ENERGY COSTS AND PROLONG THE LIFE OF YOUR EQUIPMENT.

ENERGY COSTS CONTINUE TO RISE AND YOU ARE USING MORE ELECTICITY IN YOUR HOME TODAY THAN EVER BEFORE. BUT, IT IS STILL POSSIBLE TO LOWER YOUR MONTHLY ELECTRIC BILLS.

Solution Graphics

Installation

Installation must be done by a license electrician. To do otherwise voids the warranty. The PFCD is attached to the top 220/240 volt breaker/200amp service.

By installing the PFCD in this location, you are hitting both sides of the bus bar in your panel insuring amperage surge protection.

Disclaimer

We, Power2Savings.com (Power2Savings LLC) advise consulting with a qualified Electrician when installing the PFCD. Any local electrician can install the unit within 30 min's. Power2Savings can provide a certified Electrician to install your device for $149.00. These instructions are an example and should could be different to your electrical panel. We do not recommend trying to install the device by yourself as this can void the warranty

A PFU unit can be installed on an outdoor electrical panel or an indoor Panel

Setting UpSetting Up

Open PanelOpen Panel

1. ACCESSING DISCONNECT PANEL.

Opening Service Disconnect CoverOpening Service Disconnect Cover

Service Disconnect Panel RemovedService Disconnect Panel Removed

2. TAKE PANEL COVER OFF AND DRILL A 7/8 INCH HOLE IN CORNER.

Meter "Before" ReadingMeter "Before" Reading

Insert Wire Protector in Bottom of PanelInsert Wire Protector in Bottom of Panel

Thread Wires from Unit Through HoleThread Wires from Unit Through Hole

Threading WiresThreading Wires

Start Nut on Cable ProtectorStart Nut on Cable Protector

Place KVAR PFC UnitPlace Power Factor Control Unit

Fastening Cable ProtectorFastening Cable Protector

Screw KVAR PFC Unit to WallScrew Power Factor Control Unit to Wall

Strip Wire EndsStrip Wire Ends

3. TURN OFF FIRST DOUBLE-POLE BREAKER CLOSEST TO MAIN FEEDS.

Fasten Ground LeadFasten Ground Lead

Fasten Two Hot Leads to Off BreakerFasten Two Hot Leads to Off Breaker

4. CONNECT THE GREEN WIRE TO GROUNDING BAR.

5. LOOSEN TWO SCREWS UNDER BREAKER.

6. SLIP ONE RED WIRE UNDER EACH SCREW AND TIGHTEN.

Disconnect Cover Back OnDisconnect Cover Back On

Turn Breaker to KVAR PFC Unit onTurn Breaker to Power Factor Control Unit on

It's OnIt's On Start Saving Every month

7. TURN BREAKER BACK ON AND REPLACE COVER.

8. LIGHT SHOULD BE LIT.